[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-users] XCP networking

  • To: rvegas <robertvegas@xxxxxxxxxxx>
  • From: Todd Deshane <todd.deshane@xxxxxxx>
  • Date: Sat, 19 Feb 2011 00:57:20 +0000
  • Cc: xen-users@xxxxxxxxxxxxxxxxxxx
  • Delivery-date: Fri, 18 Feb 2011 16:59:30 -0800
  • Domainkey-signature: a=rsa-sha1; c=nofws; d=gmail.com; s=gamma; h=mime-version:sender:in-reply-to:references:from:date :x-google-sender-auth:message-id:subject:to:cc:content-type; b=igkw9AYUKJskwfPxmNC/R5uL/l5wmzZg9hLbWwAwjNaAw4kvsByAvpvfMMm1sY6agz AoSKPcxR2uGXKRRYJZELHL/L1gEC3dSBtQuzqFWKguaeyjK4t6F8ojZBCJui5o/kb9nL AIr1q27r/2mrURDRaQsLpduxMCPPph56vEisI=
  • List-id: Xen user discussion <xen-users.lists.xensource.com>

On Fri, Feb 18, 2011 at 7:45 PM, rvegas <robertvegas@xxxxxxxxxxx> wrote:
> I have setup XCP on 2 X hp bl460c blades within a c7000 enclosure. The
> enclosure cisco 3020 switch has a trunk setup to a cisco 6500.
> reading through the docs it says that xcp will use a virtual switch and
> vlans. i'm a bit confused on how to setup the nic of the actual blade.
> the only option i have is to set it up as an access port. which means that
> its part of only one vlan.
> vm1 --- vswitch= vlan 12
> vm2 --- vswitch= vlan 14
> blade nic0 = vlan 12
> enclosure trunk vlan 12, 14
> so with the setup above, only packets from vm1 will get forwarded. i guess
> this is more of a cisco question.

from: http://support.citrix.com/article/CTX123489
"Configuring the XenServer management interface on a VLAN network is
not supported"

So be sure to use a different nic (not the management one) for your vlan stuff.

Creating vlans:

Xen-users mailing list



Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.