[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Xen-users] XCP networking

I have setup XCP on 2 X hp bl460c blades within a c7000 enclosure. The
enclosure cisco 3020 switch has a trunk setup to a cisco 6500.
reading through the docs it says that xcp will use a virtual switch and
vlans. i'm a bit confused on how to setup the nic of the actual blade.
the only option i have is to set it up as an access port. which means that
its part of only one vlan.

vm1 --- vswitch= vlan 12
vm2 --- vswitch= vlan 14

blade nic0 = vlan 12

enclosure trunk vlan 12, 14

so with the setup above, only packets from vm1 will get forwarded. i guess
this is more of a cisco question.
View this message in context: 
Sent from the Xen - User mailing list archive at Nabble.com.

Xen-users mailing list



Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.