Re: [Xen-users] trouble installing

[Ted Brenner <griztown@xxxxxxxxx>]

Thanks for your help and patience everyone.  I set up the interfaces file as described and everything worked.  The only note is the pan0 still exists.  Not sure where that's coming from.  Any ideas?  Just leave it?

On Wed, Feb 23, 2011 at 7:42 AM, Fajar A. Nugraha <list@xxxxxxxxx> wrote:

On Wed, Feb 23, 2011 at 8:38 PM, Ted Brenner <griztown@xxxxxxxxx> wrote:
> Thanks Fajar and Pasi,
>
> I'm not sure how to add my IP to the bridge.  It tells me 10.0.0.3 is not an
> interface.  I'm sorry if I don't know much about networking.
>
> Here's my /etc/network/interface
>
> # more /etc/network/interfaces
> # This file describes the network interfaces available on your system
> # and how to activate them. For more information, see interfaces(5).
>
> # The loopback network interface
> auto lo
> iface lo inet loopback
>
> # The primary network interface
> allow-hotplug eth0
> #NetworkManager#iface eth0 inet dhcp

That's it? No mention about br0 whatsoever on /etc/network/interfaces?

Then start by following the example /etc/network/interfaces on the
debian wiki. It should be clear enough. You HAVE, read the wiki page,
right?

--
Fajar

-- 
Ted Brenner
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users