[Xen-users] Re: OpenSuse 11 PV domU installation problem

[Flavio <fbcyborg@xxxxxxxxx>]

On 16 November 2011 18:49, Flavio <fbcyborg@xxxxxxxxx> wrote:
> I will keep you up to date.
The installation has finished. The virtual machine has stopped after the
setup has finished and the following message appeared:

> openSUSE Installation
>
> - there are shells running on consoles 2, 5, 6, 9
> - use 'extend' to load extensions (remove with 'extend -r'); extensions are:
>    o bind, gdb
> - network setup: run, e.g. 'dhcpcd eth0'
> - sshd: run 'rcsshd start' (don't forget to set a password with 'passwd')
>
> 192:~ # yast
> unicode_start skipped on /dev/pts/0
> Probing connected terminal...
>
> Initializing virtual console...
>
> Found an xterm terminal on /dev/pts/0 (136 columns x 48 lines).
> *** Starting YaST2 ***

here I proceeded with the installation and when it finished I've got:

>
> *** Preparing SSH installation for reboot ***
> *** NOTE: after reboot, you have to reconnect and call ***
> *** /usr/lib/YaST2/startup/YaST2.ssh ***
> unicode_stop skipped on /dev/pts/0

I tried to reboot, using the same config file, but I couldn't perform such
command. At this point, the setup has finished but I don't know how to
proceed to start the domU.

Actually if I use the following config file:
name="OpenSuse11"
memory=1024
disk = 
['phy:/dev/loop0,hdc:cdrom,r','file:/mnt/xen/vmstore/opensuse11/opensuse11.img,xvda,w'
]
vif = [ 'type=ioemu, mac=00:16:3e:00:00:21, bridge=xenbr0' ]
vfb = [ "type=vnc,vncunused=1,vnclisten=0.0.0.0,keymap=it" ]
stdvga=1
videoram=16
bootloader = "/usr/bin/pygrub"
vcpus=1
on_reboot = 'restart'
on_crash = 'restart'

I see this error:
failed to run bootloader: -3

Suggestions?

--
Flavio

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users