[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Xen-users] Problems with serial IO PCI card in DomU

  • To: xen-users@xxxxxxxxxxxxxxxxxxx
  • From: "S. Kremer" <sk71@xxxxxx>
  • Date: Sun, 15 Jan 2012 11:37:53 +0100
  • Delivery-date: Sun, 15 Jan 2012 10:39:31 +0000
  • List-id: Xen user discussion <xen-users.lists.xensource.com>

Hi @ll,

i have problems to use serial io pci card under domu.

Serial card:
08:03.0 Multiport serial controller: SUNIX Co., Ltd. Device 1999

I compiled the snx driver/modules at dom0and load successfully the module:

================ Found  2 SUNIX port , list informations
                                             SUNIX driver ver --

ttySNX0 --
SUNIX 5037 Series (bus:8 device: 3) , base address = ec00,    irq = 16

ttySNX1 --
SUNIX 5037 Series (bus:8 device: 3) , base address = ec08,    irq = 16


Then i use the following commands to unbind the pci card from xen

echo -n 0000:08:03.0 > /sys/bus/pci/drivers/pciback/new_slot
echo -n 0000:08:03.0 > /sys/bus/pci/drivers/pciback/bind

and my domU config:

pci = [ '08:03.0']
irq = [ 16 ]
ioports = [ "ec00-ec07", "ec08-ec0f" ]

in domU lspci shows me the correct Sunix card, but i can not insert
module to use the card (io ports) in domU.

What can I do to make the serial IO card running at domU?

I would like use this card or one port of it for a analog fax modem and
hylafax in domU. Perhaps there is another way to solve my problem.

Best regards

Xen-users mailing list



Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.