Re: [Xen-users] multipathing XCP 1.6

[motty cruz <motty.cruz@xxxxxxxxx>]

First Thank you for your reply, I will take note of xenserver mailling list. 

SR is lvmoiscsi, 

# cat /sys/block/sda/device/vendor 

ServeRA 

# cat /sys/block/sda/device/model

hanet           

The device is Hitachi

I am running XCP 1.6

Thanks again!

-Motty

On Wed, Sep 18, 2013 at 10:01 AM, Errol Neal <eneal@xxxxxxxxxxxxxxxxx> wrote:

On Tue, 09/17/2013 11:06 PM, motty cruz <motty.cruz@xxxxxxxxx> wrote:
> Hello, I hope to be in the right list. my question is the following. I
> can't seem to get multipathing configure on XCP 1.6. In XenCenter I was
> able to enable "Multipath" however, in the LUN under general tab I see "
> multipath 1 of 1 active", the the CLI I do the following command xe --m
> node session it list only one session.
>
> Can someone help me please?
>
> Thanks in advance.
> -Motty

Hi there. I think they want to move xenserver/xcp discussions over the xenserver.org mailling list, but please tell me what kind of SR are you creating?
Is it lvmohba or lvmoiscsi?
Also, what kind of device is it? NetApp?SCST?Dell? Etc? Depending upon the device, you may need to edit the multipath.conf file to control how it works.

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
http://lists.xen.org/xen-users