[Xen-users] ARM: Xen on Vexpress

[Jeenu Viswambharan <Jeenu.Viswambharan@xxxxxxx>]

Hi,

I've built necessary files and setup uboot and board to boot Xen on
Vexpress following the Wiki page. But what I see is u-boot going silent,
presumably after it jumps to Xen. My logs are attached.

I've a couple of questions:

  - I've noticed from the Vexpress Wiki that the u-boot variable
    xen_addr_r is set to 0x80400000, but the xen-uImage is built with
    both load and entry addresses as 0x80200000. I also checked the
    xen/xen.axf file (from which xen/xen is built), and its entry too is
    0x80200000. I'm afraid to ask if this a typo/bit rot in the Wiki?

    Anyway, I retried boot procedure with xen_addr_r set to 0x80200000
    instead, but this time I got an UNDEF at instruction at 0x80200008

  - Are there any logs that I can enable in Xen so that I'd know what's
    going on?

Thanks.

--
Jeenu

-- IMPORTANT NOTICE: The contents of this email and any attachments are 
confidential and may also be privileged. If you are not the intended recipient, 
please notify the sender immediately and do not disclose the contents to any 
other person, use it for any purpose, or store or copy the information in any 
medium.  Thank you.

ARM Limited, Registered office 110 Fulbourn Road, Cambridge CB1 9NJ, Registered 
in England & Wales, Company No:  2557590
ARM Holdings plc, Registered office 110 Fulbourn Road, Cambridge CB1 9NJ, 
Registered in England & Wales, Company No:  2548782

Attachment: xen.log.gz
Description: xen.log.gz

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
http://lists.xen.org/xen-users