[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-users] [TestDay] minor bug + possible configuration bug 4.5rc4 archlinux



> Depending on which behaviour you are after you should drop either
> EFI_DIR or EFI_VENDOR from your cfg I think. I think the intention is
> that people only normally specify EFI_VENDOR.

> Ian.

Ian,
  Thank you I did not know that. I will add information as comment in PKGBUILD.
I had an error in a previous xen ver if I didn't put i the EFI_VENDOR. I saw in docs that 
EFI_DIR let you put the efi directly were it was to go. I will comment out EFI_VENDOR.
as soon as I get the PKGBUILD 100% stable then I will likely reformat so my /boot is FAT32 
so that the kernels will be updates properly. My current test box is setup with
sda1 as fat32, sda2 & xen-dom0 as ext4. I am booting off of /boot/efi/EFI/arch_grub
so when I had things wrong and xen.efi failed it fell back to grub2 and booted xen.

# lsblk
sda            8:0    0   477G  0 disk 
  sda1         8:1    0   512M  0 part /boot/efi
  sda2         8:2    0   244M  0 part /boot
  sda3         8:3    0 476.2G  0 part 
  xen-dom0 254:0    0  28.2G  0 lvm  /
  xen-win8 254:1    0   100G  0 lvm  
sdb            8:16   1  29.8G  0 disk 
  sdb1         8:17   1  29.8G  0 part 
sr0           11:0    1   3.1G  0 rom  

The xen.conf had all of these in it. Is there something in my parameters(below) that is
also causing all these to be populated?

#xen-evtchn builtin kernel
#xen-gntdev builtin kernel
# xen-gntalloc builtin kernel
xen-blkback
#xen-netback builtin kernel
#xen-pciback builtin kernel
#evtchn no module
#gntdev no module
#netbk no module
#blkbk no module
#xen-scsibk no module
#usbbk no module
#pciback no module
xen-acpi-processor
#blktap2 no module
#blktap no module




> The report states "/run/run/xenstored"? Please tell how you did
> run "configure".

> Olaf


All,
  Since what you all talked about I am really hoping I configured something incorrectly here as in the EFI_VENDOR case.
My bad sorry I didn't think that most probably aren't familiar with Arch on top of which I didn't point that I was trying to make  
an arch package so the parameters. compile configuration,  the dependencies etc were in the attached PKGBUILD.
Here are the parameters
   export xen_export_check="true"
   export AS86=/usr/bin/as86
   export BASH=/usr/bin/bash   
   export BCC=/usr/bin/bcc
   export BISON=/usr/bin/bison
   export CMAKE=/usr/bin/cmake
   export COMPILER_PATH=/usr/bin
   export CURL=/usr/bin/curl-config
   export EFI_VENDOR=arch
   export EFI_DIR=/boot/efi/EFI/arch_grub 
   export BOOT_DIR=/boot/
   export FIG2DEV=/usr/bin/fig2dev
   export FLEX=/usr/bin/flex
   export IASL=/usr/bin/iasl
   export LD86=/usr/bin/ld86
   export LD_EFI=/usr/x86_64-w64-mingw32/bin/ld
   export MARKDOWN=/usr/bin/markdown
   export PANDOC=/usr/bin/pandoc
   export PERL=/usr/bin/perl
   export PKG_CONFIG=/usr/bin/pkg-config
   export POD2HTML=/usr/bin/core_perl/pod2html
   export POD2MAN=/usr/bin/core_perl/pod2man
   export POD2TEXT=/usr/bin/core_perl/pod2text
   export PYTHON="/usr/bin/python2"
   export XML=/usr/bin/xml2-config
   export XGETTEXT=/usr/bin/xgettext

   # Things that should not be exported that will break this git build
   #export ZLIB_URL="http://xenbits.xen.org/xen-extfiles/zlib-1.2.3.tar.gz"
   #export LIBPCI_URL="http://xenbits.xen.org/xen-extfiles/pciutils-2.2.9.tar.bz2"
   #export NEWLIB_URL="http://xenbits.xen.org/xen-extfiles/newlib-1.16.0.tar.gz"
   #export LWIP_URL=" http://xenbits.xen.org/xen-extfiles/lwip-1.3.0.tar.gz"
   #export GRUB_URL="http://xenbits.xen.org/xen-extfiles/grub-0.97.tar.gz"
   #export OCAML_URL="http://caml.inria.fr/ocaml/pub/distrib/ocaml-4.02/ocaml-4.02.1.tar.gz"
   #export GMP_URL="http://xenbits.xen.org/xen-extfiles/gmp-4.3.2.tar.bz2"
   #export POLARSSL_URL="http://xenbits.xen.org/xen-extfiles/polarssl-1.1.4-gpl.tgz"
   #export TPMEMU_URL="http://xenbits.xen.org/xen-extfiles/tpm_emulator-0.7.4.tar.gz"


  msg2 "Starting make..."
    ./autogen.sh
    ./configure                                          \
       --prefix=/usr                                     \
       --libdir=/usr/lib/                                \
       --bindir=/usr/bin/                                \
       --sbindir=/usr/bin/                               \
       --enable-rpath                                    \
       --localstatedir=/run                              \
       --with-sysconfig-leaf-dir="default"               \
       --with-system-ovmf="/usr/share/ovmf"              \
       --with-xenstored=oxenstored                       \
       --enable-systemd                                  \
       --with-systemd="/usr/lib/systemd/system"          \
       --with-systemd-modules-load="/etc/modules-load.d" \
       --enable-stubdom
#     --with-initddir="/etc/xen/scripts" \
#     --enable-blktap2 \ 
#     --with-linux-backend-modules="xen-evtchn xen-gntdev xen-gntalloc xen-blkback xen-netback xen-pciback xen-acpi-processor" 
# --enable-caml-stubdom  
### need to check this -> --with-initddir="/etc/xen/scripts"

I manually created /run/lib/xenstored when I rebooted it was gone
I noticed for some reason in my email I cut the bottom off the error message so here 
is the complete message plus some additional systemctl info

[root@archxen ~]# systemctl status var-lib-xenstored.mount
● var-lib-xenstored.mount - mount xenstore file system
   Loaded: error (Reason: Invalid argument)
   Active: inactive (dead)
    Where: /run/lib/xenstored
     What: xenstore

Jan 11 12:37:20 archxen systemd[1]: var-lib-xenstored.mount's Where= setting doesn't match unit name. Refusing.
Jan 11 12:37:20 archxen systemd[1]: var-lib-xenstored.mount's Where= setting doesn't match unit name. Refusing.
Jan 11 12:37:22 archxen systemd[1]: var-lib-xenstored.mount's Where= setting doesn't match unit name. Refusing.




[root@archxen ~]# systemctl status xenstored.service
● xenstored.service - The Xen xenstore
   Loaded: loaded (/usr/lib/systemd/system/xenstored.service; disabled; vendor preset: disabled)
   Active: failed (Result: exit-code) since Sun 2015-01-11 12:21:57 CST; 1min 57s ago
  Process: 325 ExecStart=/bin/sh -c exec $XENSTORED --no-fork $XENSTORED_ARGS (code=exited, status=2)
  Process: 322 ExecStartPre=/bin/mkdir -p /run/run/xen (code=exited, status=0/SUCCESS)
  Process: 319 ExecStartPre=/bin/rm -f /run/lib/xenstored/tdb* (code=exited, status=0/SUCCESS)
  Process: 311 ExecStartPre=/bin/grep -q control_d /proc/xen/capabilities (code=exited, status=0/SUCCESS)
 Main PID: 325 (code=exited, status=2)
   Status: "Mismatch on number (2): Invalid request descriptor"
    Error: 53 (Invalid request descriptor)

Jan 11 12:21:57 archxen sh[325]: Expected 2 fds but given 1
Jan 11 12:21:57 archxen sh[325]: Fatal error: exception Failure("ocaml_sd_listen_fds() mismatch")
Jan 11 12:21:57 archxen systemd[1]: xenstored.service: main process exited, code=exited, status=2/INVALIDARGUMENT
Jan 11 12:21:57 archxen systemd[1]: Failed to start The Xen xenstore.
Jan 11 12:21:57 archxen systemd[1]: Unit xenstored.service entered failed state.
Jan 11 12:21:57 archxen systemd[1]: xenstored.service failed.



journalctl _PID=325
-- Logs begin at Sat 2014-12-20 04:39:45 CST, end at Mon 2015-01-12 12:37:28 CST. --
Dec 25 18:57:51 localhost systemd-fsck[325]: /dev/sda2: clean, 354/62496 files, 78342/249856 blocks
-- Reboot --
Dec 26 13:39:36 localhost sh[325]: Expected 2 fds but given 1
Dec 26 13:39:36 localhost sh[325]: Fatal error: exception Failure("ocaml_sd_listen_fds() mismatch")
-- Reboot --
Dec 26 14:22:54 localhost dhcpcd[325]: version 6.6.7 starting
Dec 26 14:22:54 localhost dhcpcd[325]: enp5s0: adding address fe80::42d8:d41e:f5f5:d2e9
Dec 26 14:22:54 localhost dhcpcd[325]: enp5s0: waiting for carrier
Dec 26 14:22:57 localhost dhcpcd[325]: enp5s0: carrier acquired
Dec 26 14:22:57 localhost dhcpcd[325]: DUID 00:01:00:01:1c:28:0e:72:d0:50:99:27:72:4e
Dec 26 14:22:57 localhost dhcpcd[325]: enp5s0: IAID 99:27:72:45
Dec 26 14:22:57 localhost dhcpcd[325]: enp5s0: rebinding lease of 192.168.1.234
Dec 26 14:22:58 localhost dhcpcd[325]: enp5s0: soliciting an IPv6 router
Dec 26 14:23:02 localhost dhcpcd[325]: enp5s0: leased 192.168.1.234 for 86400 seconds
Dec 26 14:23:02 localhost dhcpcd[325]: enp5s0: adding route to 192.168.1.0/24
Dec 26 14:23:02 localhost dhcpcd[325]: enp5s0: adding default route via 192.168.1.1
Dec 26 14:23:02 localhost dhcpcd[325]: forked to background, child pid 494
-- Reboot --
Jan 09 17:53:49 archxen sh[325]: Fatal error: exception Failure("ocaml_sd_listen_fds() failed to get any sockets"
-- Reboot --
Jan 11 11:35:55 archxen sh[325]: Fatal error: exception Failure("ocaml_sd_listen_fds() failed to get any sockets"
-- Reboot --
Jan 11 12:15:02 archxen sh[325]: Expected 2 fds but given 1
Jan 11 12:15:02 archxen sh[325]: Fatal error: exception Failure("ocaml_sd_listen_fds() mismatch")
-- Reboot --
Jan 11 12:21:57 archxen sh[325]: Expected 2 fds but given 1
Jan 11 12:21:57 archxen sh[325]: Fatal error: exception Failure("ocaml_sd_listen_fds() mismatch")



_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
http://lists.xen.org/xen-users

 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.