[Xen-users] Booting xen using uboot+efi on Rock64

[Todd Stellanova <todd@xxxxxxxxxxxxx>]

Hello,

I'm trying to get Xen running on the Rock64 SBC (Rockchip RK3328).

The long details of my setup are here: https://forum.pine64.org/showthread.php?tid=6059

Basically I'm at a point where I am able to manually kick off efi boot from a uboot command line and getting a couple of errors (FDT_ERR_BADMAGIC and one that looks like it's coming from the EFI loader)-- see the output from uboot below.

Any suggestions on what to try next?

```

=> set devtype mmc

=> set devnum 1

=> set distro_bootpart 6

=> run boot_efi_binary

reading efi/boot/bootaa64.efi

885072 bytes read in 129 ms (6.5 MiB/s)

libfdt fdt_check_header(): FDT_ERR_BADMAGIC

## Starting EFI application at 02000000 ...

Card did not respond to voltage select!

mmc_init: -95, time 10

Scanning disk rksdmmc@xxxxxxxxxxxx...

Scanning disk rksdmmc@xxxxxxxxxxxx...

Found 2 disks

Xen 4.11-rc (c/s Tue May 1 09:03:13 2018 +0100 git:0306a1311d) EFI loader

Couldn't obtain the File System Protocol Interface: ErrCode: 0x8000000000000003

## Application terminated, r = 0

```

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxxx
https://lists.xenproject.org/mailman/listinfo/xen-users