Re: [Wg-test-framework] rimava0

["Paul L. George" <pgeorge@xxxxxxxxxx>]

Ian, 

I went back to the COLO and worked with Don to see if we could figure out
what was going on.  We loop backed tested the suspected port and it did not
loop back.  I moved the loop back plug to Gateshead Comtrol 31 and that port
passed.  I put a new Null Modem Adaptor and new CAT5 cable on Rimava0 and
then plugged it into the tested Comtrol port.  It still did not work.    My
next step is to test the Adaptor-CAT5 cable "end-to-end",  then see if we
can loopback test it connected to the Comtrol Port.  It has to be the cable,
all the other component s seem to be working fine.

Paul

-----Original Message-----
From: Ian Jackson [mailto:Ian.Jackson@xxxxxxxxxxxxx] 
Sent: Tuesday, May 05, 2015 2:43 PM
To: Paul L. George; wg-test-framework@xxxxxxxxxxxxxxxxxxxx
Subject: Re: rimava0

Ian Jackson writes ("rimava0"):
> I am having difficulty getting any life out of rimava0.
> 
> I'm talking to it with
>   ssh -vt root@xxxxxxxxxxxxxxxx picocom -b115200 /dev/ttyRP27 and I 
> have instructed pdu1 to turn it off, and about 15 seconds later, turn 
> it on.  I see no response on the serial port.
> 
> Could you please investigate ?  (On Tuesday.)

Do you think anyone will be able to look at this today ?

Thanks,
Ian.


_______________________________________________
Wg-test-framework mailing list
Wg-test-framework@xxxxxxxxxxxxxxxxxxxx
http://lists.xenproject.org/cgi-bin/mailman/listinfo/wg-test-framework