[Xen-devel] error in creating another domain

[Qian Huang <qhuang@xxxxxxxxx>]

Being a newbie of Xen, I am probably asking a question previously raised,
if so, please point me to the answer.
I made a hard drive installation of Xen1.2 from the CD. It runs perfect
with domain0. But I encountered some problems when I was tring to create
a second domain. Basically, I followed the instruction at
http://www.csc.liv.ac.uk/~u2ycc/xen/xen-install-domain-fs-howto.txt, I
built a new partition and populated the partition w/ the RH9 from the CD,
customized the configuration file.

Here is the output of xc_dom_create.py:

#xc_dom_create.py -fmyvm1.conf -Dvmid=1
Parsing config file '/etc/xc/myvm1.conf'
VM image           : "/boot/xenolinux.gz"
VM ramdisk         : ""
VM memory (MB)     : "32"
VM IP address(es)  : "169.254.1.1"
VM block device(s) : "phy:hdc1,hdc1,w"
VM cmdline         :
"ip=169.254.1.1:169.254.1.0:169.254.1.0:255.255.0.0::eth0:off
root=/dev/hdc1 ro 4 VMID=1
Error creating domain.

What could be possilbe wrong in this case? Where can I get detailed info
about this error? Is there a "debug mode" to look into?

Thanks

--qian


-------------------------------------------------------
This SF.Net email is sponsored by: IBM Linux Tutorials
Free Linux tutorial presented by Daniel Robbins, President and CEO of
GenToo technologies. Learn everything from fundamentals to system
administration.http://ads.osdn.com/?ad_id=1470&alloc_id=3638&op=click
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.sourceforge.net/lists/listinfo/xen-devel