Re: [Xen-devel] [RFC] keymap support for PVFB

["Junko Ichino" <ichino.junko@xxxxxxxxxxxxxx>]

Hi Markus,

I checked that the result of conversion had passed PVFB and gone out of
fbflont.
I think that the conversion by the OS side will go wrong.

If you know how it will pass from guest OS to guest OS's X,
please give me some comments.

When I input "\",  following message a display each modules

PVFB:
keycode 92(0x5C) -> scancode 115

xev:
keycode 176   keysym 0x0, NoSymbol


Thanks,
-
Junko Ichino


----- Original Message ----- 
From: "Markus Armbruster" <armbru@xxxxxxxxxx>
To: "Junko Ichino" <ichino.junko@xxxxxxxxxxxxxx>
Cc: <Xen-devel@xxxxxxxxxxxxxxxxxxx>
Sent: Friday, January 12, 2007 2:54 AM
Subject: Re: [Xen-devel] [RFC] keymap support for PVFB


> "Junko Ichino" <ichino.junko@xxxxxxxxxxxxxx> writes:
>
> > Hi Markus,
> >
> > Thank you for your reply.
> >
> > The key that doesn't work is \, | , _ , arrow (UP, DOWN, LEFT, and 
> > RIGHT),
> > Hankaku/Zenkaku , Muhenkan , Katakana/Hiragana and so on.
> > (When you do not know about Hankaku/Zenkaku etc., please question the
> > Japanese
> > who is in near.)
> >
> > When I looked at atkbd.c, it seemed to change scancode again.
> > I put in the same conversion immediately after changing into scancode
> > from keysym by PVFB.
> > However, it failed.
> >
> > I investigate this problem continuously.
> How can we help?
>
> _______________________________________________
> Xen-devel mailing list
> Xen-devel@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-devel 

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-devel