[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [Xen-devel] AMD Phenom II 940: mm/vmalloc.c:110 vmap_page_range_noflush
Ok, I tested with the new 2.6.32.12: (.config same) Case 1: Xen 4.0.0-rc8 / pv_ops dom0 kernel 2.6.32.12 Still pv_ops dom0 is not working properly.There are still call trace and other errors. The kernel does boot up but it takes again a long time to get the login prompt (about 3 mins). This is far longer than when I used 2.6.31.6 pv_ops dom0. Networking does not start properly (only see 'lo' and 'virbr0'), so I have to restart it manually and then I see my bridge 'br0' and 'eth0'. Can't find device "br0" /etc/xen/scripts/network-bridge: line 240: "sigerr" command not found.And it is trying unsuccessfully to start some laptop feature like S99powernap (unknown job) and also S28-libvirt-bin fails (maybe network related?). Case 2: pv_ops domU kernel 2.6.32.12 (no xen dom0):Now the straight linux kernel (no xen dom0) boots right up and goes to login prompt in normal timeframe. Networking starts correctly. Things look pretty normal. Observation:I'm getting slightly different output on console and serial console. Some errors show on one but not the other. Shouldn't these be identical? I'm attaching both serial console outputs. menu.lst is same as before (just .12 instead of .10) -Gerry Attachment:
AMD_pvops_dom0_console_2.6.32.12.txt Attachment:
AMD_pvops_domU_console_2.6.32.12.txt _______________________________________________ Xen-devel mailing list Xen-devel@xxxxxxxxxxxxxxxxxxx http://lists.xensource.com/xen-devel
|
Lists.xenproject.org is hosted with RackSpace, monitoring our |