Re: [Xen-devel] Accessing Dom0 Physical memory from xen, via direct mappings (PML4:262-271)

[Tim Deegan <tim@xxxxxxx>]

At 08:45 -0700 on 13 Mar (1331628358), Shriram Rajagopalan wrote:
> In config.h (include/asm-x86/config.h) I found this:
> 
> #if __x86_64__
> ...
>  *  0xffff830000000000 - 0xffff87ffffffffff [5TB, 5*2^40 bytes, PML4:262-271]
>  *    1:1 direct mapping of all physical memory.                   
> ...
> 
> I was wondering if it's possible for dom0 to malloc a huge chunk of memory 
> and let xen know the starting address of this range. 
> Inside xen, I can translate dom0 virt address to a virt address in the above 
> range and access the entire chunk via these virtual addresses.

Eh, maybe?  But it's harder than you'd think.  Memory malloc()ed in dom0
may not be contiguous in PFN-space, and dom0 PFNs may not be contiguous
in MFN-space, so you can't just translate the base of the buffer and use
it with offsets, you have to translate again for every 4k page.  Also, you
need to make sure dom0 doesn't page out or relocate your user-space
buffer while Xen is accessing the MFNs.  mlock() might do what you need
but AIUI there's no guarantee that it won't, e.g., move the buffer
around to defragment memory.

If you do handle all that, the correct way to get at the mappings in
this range is with map_domain_page().  But remember, this only works
like this on 64-bit Xen.  On 32-bit, only a certain amount of memory can
be mapped at one time so if the buffer is really big, you'll need to map
an unmap parts of it on demand.

But maybe back up a bit: why do you want to do this?  What's the buffer
for?  Is it something you could do more easily by having Xen allocate
the buffer and let dom0 map it?

> The catch here is that I want this virtual address range to be accessible 
> across all vcpu contexts in xen (whether it's servicing a hypercall from dom0
> or a vmx fault caused by Guest).
> 
> So far, I have only been able to achieve the former. In the latter case,
> where the "current" vcpu belongs to a guest (eg in a vmx fault handler),
> I can't access this address range inside xen. Do I have to add EPT
> mappings to guest's p2m to do this ? Or can I do something else ?

If you really have got a pointer into the 1-1 mapping it should work
from any vcpu.  But again, that's not going to work on 32-bit Xen.
There, you have to use map_domain_page_global() to get a mapping that
persists across all vcpus, and that's even more limited in how much it
can map at once.

Cheers,

Tim.

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel