Re: [Xen-devel] [PATCH 00/15] xen: arm initial support for xgene arm64 platform

[Ian Campbell <Ian.Campbell@xxxxxxxxxx>]

On Fri, 2013-11-22 at 17:02 +0000, George Dunlap wrote:
> On Fri, Nov 22, 2013 at 4:27 PM, Ian Campbell <Ian.Campbell@xxxxxxxxxx> wrote:
> > Damnit. Missed the --dry-run... Oh well, the patches are actually
> > correct I think.
> >
> > The 00/15 mail would have contained:
> >
> > This addresses the previous review.
> >
> > In particular it drops the RFC from a couple of patches and replaces the
> > HACKs with clean solutions.
> >
> > A==acked. H==replaces a HACK. R==release acked. r==might be release
> > akced but George wasn't 100% explicit.
> >
> >   R xen: arm64: Add 8250 earlyprintk support
> > A R xen: arm64: Add Basic Platform support for APM X-Gene Storm.
> > A R xen: arm64: Add APM implementor id to processor implementers.
> >  H  xen: arm: add a quirk to handle platforms with unusual GIC layout
> > A   xen: arm: allow platform code to select dom0 event channel irq
> >  H  xen: arm64: Map xgene PCI memory regions and interrupts to dom0.
> > A R xen: arm: include ns16550 driver on arm64 too
> > A r xen: arm: early logging of command line
> >   r xen: arm: Handle cpus nodes with #address-cells > 1
> >   R xen: arm: Make register bit definitions unsigned.
> > A R xen: arm: explicitly map 64 bit release address
> >   R xen: arm: enable synchronous console while starting secondary CPUs
> >   R xen: arm: Add debug keyhandler to dump the physical GIC state.
> > A R xen: arm: improve early memory map readability
> >   r xen: arm: handle 40-bit addresses in the p2m
> 
> OK -- everything looks good release-wise.

Thanks.

Ian.


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel