[Xen-devel] [PATCH v2 10/10] x86/misc: Post cleanup

[Andrew Cooper <andrew.cooper3@xxxxxxxxxx>]

* panic() now works on early boot.  Replace EARLY_FAIL()
* Cleanup __set_intr_gate() & friends.  The master IDT is fully constructed on
  early boot, and only subsequently altered on the crash path.  Make them
  private to traps.c, move them into .init, and remove the loop over all idts,
  as __set_intr_gate() will never find an AP to patch. (For some reason,
  leaving out the noinline causes ~1.5k of code bloat from GCC inlining
  everything)
* No need to clear X86_EFLAGS_NT in cpu_init().  This is covered by the eflags
  reset in __high_start().

Signed-off-by: Andrew Cooper <andrew.cooper3@xxxxxxxxxx>
CC: Keir Fraser <keir@xxxxxxx>
CC: Jan Beulich <JBeulich@xxxxxxxx>
CC: Tim Deegan <tim@xxxxxxx>

---
v2:
 * Don't page align idt_table.
 * Forgo clearing NT.
---
 xen/arch/x86/cpu/common.c  |    3 ---
 xen/arch/x86/setup.c       |   20 ++++++--------------
 xen/arch/x86/traps.c       |   11 +++--------
 xen/include/asm-x86/desc.h |    1 -
 4 files changed, 9 insertions(+), 26 deletions(-)

diff --git a/xen/arch/x86/cpu/common.c b/xen/arch/x86/cpu/common.c
index dcd2ca1..18112f2 100644
--- a/xen/arch/x86/cpu/common.c
+++ b/xen/arch/x86/cpu/common.c
@@ -593,9 +593,6 @@ void __cpuinit cpu_init(void)
        /* Install correct page table. */
        write_ptbase(current);
 
-       /* No nested task. */
-       asm volatile ("pushf ; andw $0xbfff,(%"__OP"sp) ; popf" );
-
        /* Ensure FPU gets initialised for each domain. */
        stts();
 
diff --git a/xen/arch/x86/setup.c b/xen/arch/x86/setup.c
index b2a808a..508649d 100644
--- a/xen/arch/x86/setup.c
+++ b/xen/arch/x86/setup.c
@@ -133,11 +133,6 @@ static void __init parse_acpi_param(char *s)
     }
 }
 
-#define EARLY_FAIL(f, a...) do {                \
-    printk( f , ## a );                         \
-    for ( ; ; ) halt();                         \
-} while (0)
-
 static const module_t *__initdata initial_images;
 static unsigned int __initdata nr_initial_images;
 
@@ -669,11 +664,10 @@ void __init noreturn __start_xen(unsigned long mbi_p)
 
     /* Check that we have at least one Multiboot module. */
     if ( !(mbi->flags & MBI_MODULES) || (mbi->mods_count == 0) )
-        EARLY_FAIL("dom0 kernel not specified. "
-                   "Check bootloader configuration.\n");
+        panic("dom0 kernel not specified. Check bootloader configuration.");
 
     if ( ((unsigned long)cpu0_stack & (STACK_SIZE-1)) != 0 )
-        EARLY_FAIL("Misaligned CPU0 stack.\n");
+        panic("Misaligned CPU0 stack.");
 
     if ( efi_enabled )
     {
@@ -754,9 +748,7 @@ void __init noreturn __start_xen(unsigned long mbi_p)
         e820_raw_nr = 2;
     }
     else
-    {
-        EARLY_FAIL("Bootloader provided no memory information.\n");
-    }
+        panic("Bootloader provided no memory information.");
 
     /* Sanitise the raw E820 map to produce a final clean version. */
     max_page = raw_max_page = init_e820(memmap_type, e820_raw, &e820_raw_nr);
@@ -791,7 +783,7 @@ void __init noreturn __start_xen(unsigned long mbi_p)
     for ( i = 0; !efi_enabled && i < mbi->mods_count; i++ )
     {
         if ( mod[i].mod_start & (PAGE_SIZE - 1) )
-            EARLY_FAIL("Bootloader didn't honor module alignment request.\n");
+            panic("Bootloader didn't honor module alignment request.");
         mod[i].mod_end -= mod[i].mod_start;
         mod[i].mod_start >>= PAGE_SHIFT;
         mod[i].reserved = 0;
@@ -964,7 +956,7 @@ void __init noreturn __start_xen(unsigned long mbi_p)
     }
 
     if ( modules_headroom && !mod->reserved )
-        EARLY_FAIL("Not enough memory to relocate the dom0 kernel image.\n");
+        panic("Not enough memory to relocate the dom0 kernel image.");
     for ( i = 0; i < mbi->mods_count; ++i )
     {
         uint64_t s = (uint64_t)mod[i].mod_start << PAGE_SHIFT;
@@ -973,7 +965,7 @@ void __init noreturn __start_xen(unsigned long mbi_p)
     }
 
     if ( !xen_phys_start )
-        EARLY_FAIL("Not enough memory to relocate Xen.\n");
+        panic("Not enough memory to relocate Xen.");
     reserve_e820_ram(&boot_e820, efi_enabled ? mbi->mem_upper : __pa(&_start),
                      __pa(&_end));
 
diff --git a/xen/arch/x86/traps.c b/xen/arch/x86/traps.c
index 2928743..413b97d 100644
--- a/xen/arch/x86/traps.c
+++ b/xen/arch/x86/traps.c
@@ -3422,22 +3422,17 @@ void do_debug(struct cpu_user_regs *regs)
     return;
 }
 
-static void __set_intr_gate(unsigned int n, uint32_t dpl, void *addr)
+static void __init noinline __set_intr_gate(unsigned int n, uint32_t dpl, void 
*addr)
 {
-    int i;
-    /* Keep secondary tables in sync with IRQ updates. */
-    for ( i = 1; i < nr_cpu_ids; i++ )
-        if ( idt_tables[i] != NULL )
-            _set_gate(&idt_tables[i][n], SYS_DESC_irq_gate, dpl, addr);
     _set_gate(&idt_table[n], SYS_DESC_irq_gate, dpl, addr);
 }
 
-static void set_swint_gate(unsigned int n, void *addr)
+static void __init set_swint_gate(unsigned int n, void *addr)
 {
     __set_intr_gate(n, 3, addr);
 }
 
-void set_intr_gate(unsigned int n, void *addr)
+static void __init set_intr_gate(unsigned int n, void *addr)
 {
     __set_intr_gate(n, 0, addr);
 }
diff --git a/xen/include/asm-x86/desc.h b/xen/include/asm-x86/desc.h
index 8257167..225913a 100644
--- a/xen/include/asm-x86/desc.h
+++ b/xen/include/asm-x86/desc.h
@@ -199,7 +199,6 @@ DECLARE_PER_CPU(struct desc_struct *, gdt_table);
 extern struct desc_struct boot_cpu_compat_gdt_table[];
 DECLARE_PER_CPU(struct desc_struct *, compat_gdt_table);
 
-extern void set_intr_gate(unsigned int irq, void * addr);
 extern void load_TR(void);
 
 #endif /* !__ASSEMBLY__ */
-- 
1.7.10.4


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel