Re: [Xen-devel] VGA passthrough is not working

[Maxim Gordeev <m.gordeev@xxxxxxxxxxxxx>]

no, no.
With 4.3 is bad work! With 4.4 is do not starting.
I see into lspci: BAR1 is not possible assignment. With 4.3 can not
maping BAR1.
Thanks!

09.06.2014 16:29, Gordan Bobic ÐÐÑÐÑ:
> On 06/09/2014 01:21 PM, Maxim Gordeev wrote:
>> 16Gb this is BAR1.
>> This is example my VM config:
>>> /builder='hvm'//
>>> //memory = 16000//
>>> //name = "xen-hvm-cheap1"//
>>> //vcpus=8//
>>> //acpi=0//
>>> //disk = [ //
>>> //// 'file:/opt/VM/cheap1_glinux-1.img,hda,w',//
>>> // 'file:/opt/VM/cheap1_glinux-2.img,hdb,w'//
>>> // ]//
>>> // xen_platform_pci = 1//
>>> //on_poweroff = 'destroy'//
>>> //on_reboot = 'restart'//
>>> //on_crash = 'restart'//
>>> //device_model_version = 'qemu-xen-traditional'//
>>> //boot="c"//
>>> //vnc=1//
>>> //vnclisten="0.0.0.0"//
>>> //vncdisplay=1//
>>> //vncunused=1//
>>> //vncpasswd=''//
>>> //stdvga=0//
>>> //serial='pty'//
>>> //monitor=1//
>>> //gfx_passthru=0//
>>> //pci=['03:00.0' ] /
>> Xen 4.3 start this VM, but Xen 4.4 is not starting VM.
>
> So you are saying that this works fine with 4.3 but breaks with 4.4?
>
> Gordan
>
> _______________________________________________
> Xen-devel mailing list
> Xen-devel@xxxxxxxxxxxxx
> http://lists.xen.org/xen-devel


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel