Re: [Xen-devel] [PATCH FOR-4.5] xen: arm64: Handle memory banks which are not 1GB aligned

[Julien Grall <julien.grall@xxxxxxxxxx>]

On 10/13/2014 01:35 PM, Vijay Kilari wrote:
> Hi Roy,

Hi all,

>    I too observe the same issue. I have enabled uefi_debug
> 
> (XEN) DOM0: bootconsole [uart0] enabled
> (XEN) DOM0: Memory limited to 512MB
> (XEN) DOM0: efi: Getting parameters from FDT:
> (XEN) DOM0: efi:   System Table: 0x000000007fb79f18
> (XEN) DOM0: efi:   MemMap Address: 0x000000007a88c018
> (XEN) DOM0: efi:   MemMap Size: 0x000004e0
> (XEN) DOM0: efi:   MemMap Desc. Size: 0x00000030
> (XEN) DOM0: efi:   MemMap Desc. Version: 0x00000001
> (XEN) DOM0: Unhandled fault: ttbr address size fault (0x96000000) at
> 0xffffffbffbc7ff18
> (XEN) DOM0: Internal error: : 96000000 [#1] PREEMPT SMP
> (XEN) DOM0: Modules linked in:
> (XEN) DOM0: CPU: 0 PID: 0 Comm: swapper Not tainted 3.16.0-rc4+ #3
> (XEN) DOM0: task: ffffffc0007048a0 ti: ffffffc0006f8000 task.ti:
> ffffffc0006f8000
> (XEN) DOM0: PC is at uefi_init+0x94/0x1a0
> (XEN) DOM0: LR is at uefi_init+0x84/0x1a0
> 
> I have not digged into the issue. Xen has not mapped this table to Dom0?

DOM0 should only boot with Device Tree and not using EFI. I suspect that
Xen is copying the EFI properties/nodes in the DOM0 DT.

We have to remove at least the following parameters from the device tree:

- linux,uefi-system-table
- linux,uefi-mmap-start
- linux,uefi-mmap-size
- linux,uefi-mmap-desc-size
- linux,uefi-mmap-desc-ver

Regards,

-- 
Julien Grall

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel