[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Xen-devel] [PATCHv1 net-next] xen-netback: remove unconditional pull_skb_tail in guest Tx path



From: Malcolm Crossley <malcolm.crossley@xxxxxxxxxx>

Unconditionally pulling 128 bytes into the linear buffer is not
required. Netback has already grant copied up-to 128 bytes from the
first slot of a packet into the linear buffer. The first slot normally
contain all the IPv4/IPv6 and TCP/UDP headers.

The unconditional pull would often copy frag data unnecessarily.  This
is a performance problem when running on a version of Xen where grant
unmap avoids TLB flushes for pages which are not accessed.  TLB
flushes can now be avoided for > 99% of unmaps (it was 0% before).

Grant unmap TLB flush avoidance will be available in a future version
of Xen (probably 4.6).

Signed-off-by: Malcolm Crossley <malcolm.crossley@xxxxxxxxxx>
Signed-off-by: David Vrabel <david.vrabel@xxxxxxxxxx>
---
 drivers/net/xen-netback/netback.c |   26 ++++++++++++--------------
 1 file changed, 12 insertions(+), 14 deletions(-)

diff --git a/drivers/net/xen-netback/netback.c 
b/drivers/net/xen-netback/netback.c
index 730252c..14e18bb 100644
--- a/drivers/net/xen-netback/netback.c
+++ b/drivers/net/xen-netback/netback.c
@@ -82,6 +82,16 @@ MODULE_PARM_DESC(max_queues,
 static unsigned int fatal_skb_slots = FATAL_SKB_SLOTS_DEFAULT;
 module_param(fatal_skb_slots, uint, 0444);
 
+/* The amount to copy out of the first guest Tx slot into the skb's
+ * linear area.  If the first slot has more data, it will be mapped
+ * and put into the first frag.
+ *
+ * This is sized to avoid pulling headers from the frags for most
+ * TCP/IP packets.
+ */
+#define XEN_NETBACK_TX_COPY_LEN 128
+
+
 static void xenvif_idx_release(struct xenvif_queue *queue, u16 pending_idx,
                               u8 status);
 
@@ -125,13 +135,6 @@ static inline struct xenvif_queue *ubuf_to_queue(const 
struct ubuf_info *ubuf)
                            pending_tx_info[0]);
 }
 
-/* This is a miniumum size for the linear area to avoid lots of
- * calls to __pskb_pull_tail() as we set up checksum offsets. The
- * value 128 was chosen as it covers all IPv4 and most likely
- * IPv6 headers.
- */
-#define PKT_PROT_LEN 128
-
 static u16 frag_get_pending_idx(skb_frag_t *frag)
 {
        return (u16)frag->page_offset;
@@ -1446,9 +1449,9 @@ static void xenvif_tx_build_gops(struct xenvif_queue 
*queue,
                index = pending_index(queue->pending_cons);
                pending_idx = queue->pending_ring[index];
 
-               data_len = (txreq.size > PKT_PROT_LEN &&
+               data_len = (txreq.size > XEN_NETBACK_TX_COPY_LEN &&
                            ret < XEN_NETBK_LEGACY_SLOTS_MAX) ?
-                       PKT_PROT_LEN : txreq.size;
+                       XEN_NETBACK_TX_COPY_LEN : txreq.size;
 
                skb = xenvif_alloc_skb(data_len);
                if (unlikely(skb == NULL)) {
@@ -1653,11 +1656,6 @@ static int xenvif_tx_submit(struct xenvif_queue *queue)
                        }
                }
 
-               if (skb_is_nonlinear(skb) && skb_headlen(skb) < PKT_PROT_LEN) {
-                       int target = min_t(int, skb->len, PKT_PROT_LEN);
-                       __pskb_pull_tail(skb, target - skb_headlen(skb));
-               }
-
                skb->dev      = queue->vif->dev;
                skb->protocol = eth_type_trans(skb, skb->dev);
                skb_reset_network_header(skb);
-- 
1.7.10.4


_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxx
http://lists.xen.org/xen-devel


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.