Re: [Xen-devel] [PATCH] x86/setup: do not relocate below the end of current Xen image placement

[Daniel Kiper <daniel.kiper@xxxxxxxxxx>]

On Tue, Nov 28, 2017 at 07:02:01AM -0700, Jan Beulich wrote:
> >>> On 28.11.17 at 14:53, <daniel.kiper@xxxxxxxxxx> wrote:
> > On Tue, Nov 28, 2017 at 06:37:17AM -0700, Jan Beulich wrote:
> >> >>> On 28.11.17 at 13:47, <daniel.kiper@xxxxxxxxxx> wrote:
> >> > Then all cases should be covered.
> >>
> >> I don't think that's going to be enough: Once Xen gets moved,
> >> the area to exclude needs to be updated too.
> >
> > If the Xen is relocated by the booloader then the Xen does not do relocation
> > itself again. So, it should work.
>
> Then let me reformulate this into "... the area to exclude needs to
> be set".

Oh... You mean consider_modules() with efi_enabled(EFI_LOADER) in the
same patch. Right, we can replace "efi_enabled(EFI_LOADER)" with
"!!xen_phys_start" then.

Daniel

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxx
https://lists.xenproject.org/mailman/listinfo/xen-devel