Re: [Xen-devel] Query for running Xen on ARM

[Julien Grall <julien.grall@xxxxxxx>]

Hi,

On 05/30/2018 05:18 PM, Stefano Stabellini wrote:
> I am not sure what the problem is. I would compared your partition table
> with a standard Linux distro UEFI image [1] to see if there are any
> important differences. Checkout the UEFI spec [2] section 13.3.1 onward
> to read the details of the partitions and filesystem requirements.
I may have an idea of what's going on. Looking at the picture sent, The 
disk you show seems to be the one used by your Ubuntu running in 
VirtualBox. This seems to be confirmed by your previous e-mail where you 
mention sda1. Am I right?
You need to create that partition in the image used by QEMU. But likely 
this will already be there if you use a pre-built image (e.g ubuntu or 
else). I am assuming you were booting Linux using UEFI.
Cheers,

--
Julien Grall

_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxx
https://lists.xenproject.org/mailman/listinfo/xen-devel