Re: [Xen-users] Failed to Install

[Dominik Sennfelder <mailingliste@xxxxxxxxxxxxxxxxxx>]

Daniel Hulme wrote:
> > Result
> > Unable to mount root Filesystem.
> >     
>   
> > title Xen 3.0 / XenLinux 2.6.12
> > kernel          /boot/xen.gz dom0_mem=64000
> > module          /boot/vmlinuz-2.6-xen0 root=/dev/sda1 ro console=tty0
> >     
>   
> > The Problem is that i dont see the detection of the Serveraid adpater
> > if dom0 ist booting.
> > so if the Adpater is not recognized the root fs will not be found.
> >     
> If support for your RAID card or the root filesystem is built as a
> module, you will have to either build it into the kernel (see below) or
> make an initrd and add it to your GRUB config as a second *module*, not
> using the initrd command in GRUB. You create an initrd the usual way,
> using 'mkinitrd 2.6.12-xen0'.
>   
ok i have to try that.
>   
> > Where do i have to configure the Options that the
> > dom0 Kernel uses the Drivers the actual Kernel uses?
> >     
> As described in the README, you can cd into the linux-2.6.12-xen0
> directory in the source tree and 'make ARCH=xen menuconfig'. With the
> options for building a dom0 kernel turned on (which they should be
> already) the config is very similar to the standard kernel
> configuration.
>   
I tried to configure the Kernel but i miss a lot of  Kernel Options.

Greets
Dominik



_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users