Re: [Xen-users] FC4 + Xen 2.0.6 eth0 failed

[Mark Williamson <mark.williamson@xxxxxxxxxxxx>]

What version of Xen are you guys using?  Definitely the Xen-unstable version 
that comes with FC4?  What's the package name?

Cheers,
Mark

On Thursday 25 August 2005 22:52, Danny Hembree wrote:
> from Pavel Kozubenko:
> >I am new to XEN. Just installed xen on my fedora core 4 following the
> >instructions given by Red Hat ( using 'yum'). I was able to boot to X
> >window but my eth0 is not available nor I can see my ethernet
> >interfaces anymore. I use DELL Dimension 2100 with built-in LAN
> >interface and also have one in one of PCI slots. None of them visible.
> >ANy idea why it might happen?
>
> I'm having a similar problem using the instructions at
> http://www.fedoraproject.org/wiki/FedoraXenQuickstart . I get as far as
> this line "yum -c http://people.redhat.com/~katzj/yum-xen.conf
> --installroot=/mnt -y groupinstall Base" and then it fails because there
> is no network connection. Ifconfig show the bridge, xen-br0, as up with
> TX pkgs but no RX and the correct IP information. Eth0 also displays the
> correct information with TX and RX pkgs. I can only ping the the IP of
> eth0 and 127.0.0.1. No machine can see box from the LAN. I can't ping
> the gateway either. The route command shows the gateway and subnet as
> well as 169.254.0.0 on the xen-br0 interface. There is no vif, I haven't
> been able to get to the point of creating a guest host because I can't
> execute the yum command to install it. This is on a Dell Dimension 2400.
>
>
> _______________________________________________
> Xen-users mailing list
> Xen-users@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-users

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users