[Xen-users] Re: Re: network settings

[Marco Mandl <marco.mandl@xxxxxx>]

On Fri, 20 Apr 2007 17:30:48 +0200, Marco Mandl wrote:

> On Fri, 20 Apr 2007 17:58:46 +0800, Tim Post wrote:
> 
>> Opposite. In the dom-u, you replace xen-br0 with eth0. 
> 
> Which IP adresse this eth0 should have - the one of the physical eth0 of
> dom0?
>> 
> 
> The start of xend does not create an interface. I am not aware of having
> changed anything except in xend-config:
> (network-script 'network-bridge netdev=eth0')
> (vif-script vif-bridge)
> 
I found the problem - bridge-utils where not installed. Now I get
# ifconfig -s
Iface   MTU Met   RX-OK RX-ERR RX-DRP RX-OVR   TX-OK TX-ERR TX-DRP TX-OVR Flg
eth0   1500 0       486      0      0      0      344      0      0      0 BMRU
lo    16436 0         0      0      0      0        0      0      0      0 LRU
peth0  1500 0       481      0      0      0      343      0      0      0 BORU
vif0.  1500 0       344      0      0      0      486      0      0      0 BORU
xenbr  1500 0        10      0      0      0        0      0      0      0 BORU

But still the domU is not started. I get the following error:
> 
> # xm create domu-sarge -c
> Using config file "/etc/xen/domu-sarge".
> Error: Device 0 (vif) could not be connected. Hotplug scripts not working.
> 

/m



_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users