Re: [Xen-users] PPPoE in DomU exits with error

[kanour-xen <xen@xxxxxxxxxx>]

Christian Lyra wrote:
> >  >
> >  > fwx:/home/lyra# ethtool -i internet
> >  > driver: 8139too
> >  > version: 0.9.27
> >  > firmware-version:
> >  > bus-info: 0000:01:08.0
> >
> >  I am assuming that your interface info was from DomU. I actually
> >  compared few machines and all real (hw - not xen created) interfaces
> >  have PHYD [some number]. I mean in dom0 and other non xen machines.
> 	Oh... yes... real hardware on domU (pciback). 
>
> >  The problem is that I don't know what it means :-). Maybe there
> > should be some number and this indicates that it works as hardware
> > interface.
> >  Another question, do you run udev or hotplug on DomU? I don't.
>         Yes. I do. From my z25_persistent-net.rules:
>
>
> # Xen virtual device (8139too)
> SUBSYSTEM=="net", DRIVERS=="?*", ATTRS{address}=="00:e0:7d:d9:25:61", 
> NAME="internet"
> But i guess maybe you have a point about the pciex. But... as I 
> understand you got the interface running right? if you plug the 
> interface to your switch, it works? 
Yes the interface runs fine and it works. I can ping the ADSL modem no 
problem as other devices on the same subnet.
Can you tell me one more thing in regards to bus-info above.
Does the number there corresponds to lspci number of the same device in 
dom0?
I have:
Dom0 - 0000:86:01.0 Ethernet controller: Intel Corporation 82541PI 
Gigabit Ethernet Controller (rev 05)
DomU
alsfw01:~# ethtool -i eth2
>  driver: e1000
>  version: 7.1.9-k4-NAPI
>  firmware-version: N/A
>  bus-info: 0000:00:01.0

They don't correspond to each other.

Jiri

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users