Re: [Xen-users] How do I set this network up?

[Sadique Puthen <sputhenp@xxxxxxxxxx>]

Steve H wrote:
> Hi there,
>
> I've been browsing around trying to find the best way to set this up, 
> but I'm a bit stumped.
> I want to use one interface on my dom0, with multiple domU's.
>
> Each domU should have a private IP (10.0.0.xxx), and optionally a 
> public IP as well.
> The public IP should be eth0, the private one should be eth1.
>
> The public IP's are drawn from two ranges, on different subnets with 
> different gateways.
> For the sake of example, these ranges are:
>
> 100.100.100.xxx, gateway 100.100.100.94,  netmask 255.255.255.224
> 200.200.200.xxx, gateway 200.200.200.254, netmask 255.255.255.0
>
> And the private range would be:
>
> 10.0.0.xxx
>
> So, the dom0 might be
>
> eth0    100.100.100.123
> eth1    10.0.0.1
>
> And a domU might be
>
> eth0    100.100.100.124
> eth1    10.0.0.2
>
> But it could also be
>
> eth0    200.200.200.46
> eth1    10.0.0.3
>
> or it could be
>
> eth0    (none)
> eth1    10.0.0.4
One solution is to use eth0 from dom0 for 100.x.x.x network and eth1 for 
200.x.x.x and use a virtual interface - Eg, virbr0 - for private lan ip 
addresses. The only problem with this is that the only systems in the 
private network should be the guests.
If the above is not acceptable, you can configure eth0 with 100.x.x.x 
and eth0:1 with 200.x.x.x and bridge both to a bridge.  I have not 
tested this, but somebody says to me this is supposed to work. Good luck.
--Sadique

> Any help in this matter would be greatly appreciated!
>
> Thanks in advance.
>
> Steve
>
> _______________________________________________
> Xen-users mailing list
> Xen-users@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-users

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users