[Xen-users] HVM tap:aio and net under FC8

["Gary W. Smith" <gary@xxxxxxxxxxxxxxx>]

Hello,

 

I'm trying to setup a Windows instance under Xen 3.1.0 via FC8.  I managed to get it working fine except that I must use file: instead of tap:aio and I've also run into problems with the network not working under the DomU.  Apparently quem is looking for xenbr(X) and it doesn't exist. 

 

Setting xenbr0 in the /etc/xend-config.sxp with bridge=xenbr0 causes Dom0 to lose network connectivity.  I should also note that my ethernet interface is actually eth2 (eth0-1 are disabled on boot).

 

Out of the box, what do I need to do to tweak FC8 in order to support tap:aio and more importantly network?

 

Gary

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users