[Xen-users] e1000e not working with latest linux-2.6.18-xen.hg

[Balaji Rao <balajirrao@xxxxxxxxx>]

Hello all,

My e1000e card does not work with linux-2.6.18-xen.hg. The lspci -x output from 
a working 2.6.25-14 f9 kernel is,

00:19.0 Ethernet controller: Intel Corporation 82566DC-2 Gigabit Network 
Connection (rev 02)
00: 86 80 4c 29 07 00 10 00 02 00 00 02 00 00 00 00
10: 00 00 38 e0 00 40 3a e0 e1 20 00 00 00 00 00 00
20: 00 00 00 00 00 00 00 00 00 00 00 00 86 80 01 00
30: 00 00 00 00 c8 00 00 00 00 00 00 00 09 01 00 00


lspci -vvv says,

00:19.0 Ethernet controller: Intel Corporation 82566DC-2 Gigabit Network 
Connection (rev 02)
        Subsystem: Intel Corporation Unknown device 0001
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- 
Stepping- SERR- FastB2B- DisINTx-
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- 
<MAbort- >SERR- <PERR- INTx-
        Latency: 0
        Interrupt: pin A routed to IRQ 20
        Region 0: Memory at e0380000 (32-bit, non-prefetchable) [size=128K]
        Region 1: Memory at e03a4000 (32-bit, non-prefetchable) [size=4K]
        Region 2: I/O ports at 20e0 [size=32]
        Capabilities: [c8] Power Management version 2
                Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA 
PME(D0+,D1-,D2-,D3hot+,D3cold+)
                Status: D0 PME-Enable- DSel=0 DScale=1 PME-
        Capabilities: [d0] Message Signalled Interrupts: Mask- 64bit+ Queue=0/0 
Enable-
                Address: 0000000000000000  Data: 0000
        Capabilities: [e0] Vendor Specific Information <?>
        Kernel driver in use: e1000e
        Kernel modules: e1000e

Are there any floating patches to help me fix this ? Please help.

Thank you.
-- 
Warm Regards,

Balaji Rao

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users