Hello all,
My e1000e card does not work with linux-2.6.18-xen.hg. The lspci -x output from
a working 2.6.25-14 f9 kernel is,
00:19.0 Ethernet controller: Intel Corporation 82566DC-2 Gigabit Network
Connection (rev 02)
00: 86 80 4c 29 07 00 10 00 02 00 00 02 00 00 00 00
10: 00 00 38 e0 00 40 3a e0 e1 20 00 00 00 00 00 00
20: 00 00 00 00 00 00 00 00 00 00 00 00 86 80 01 00
30: 00 00 00 00 c8 00 00 00 00 00 00 00 09 01 00 00
lspci -vvv says,
00:19.0 Ethernet controller: Intel Corporation 82566DC-2 Gigabit Network
Connection (rev 02)
Subsystem: Intel Corporation Unknown device 0001
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort-
<MAbort- >SERR- <PERR- INTx-
Latency: 0
Interrupt: pin A routed to IRQ 20
Region 0: Memory at e0380000 (32-bit, non-prefetchable) [size=128K]
Region 1: Memory at e03a4000 (32-bit, non-prefetchable) [size=4K]
Region 2: I/O ports at 20e0 [size=32]
Capabilities: [c8] Power Management version 2
Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA
PME(D0+,D1-,D2-,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=1 PME-
Capabilities: [d0] Message Signalled Interrupts: Mask- 64bit+ Queue=0/0
Enable-
Address: 0000000000000000 Data: 0000
Capabilities: [e0] Vendor Specific Information <?>
Kernel driver in use: e1000e
Kernel modules: e1000e
Are there any floating patches to help me fix this ? Please help.
Thank you.
