[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [Xen-users] Ubuntu 8.04 Hardy Heron bridged networking xen connectivity loss
Last problem I had involved changing one character in my configuration scripts. Really easy once someone showed me what was wrong. Well I think this issue is just the same. The moment I used apt to install the Xen kernal and tools I lost internet connectivity. I have been managing because I can restore connectivity be deleting the bridge mpower@dodtsair:~$ sudo ifdown eth0 mpower@dodtsair:~$ sudo brctl delbr eth0But that means any domUs will not have connectivity. I have not had any till now so it wasn't much of an issues. But thanks to your help now I have XP running. Ultimately I would really like you to show me the documentation that tells me how to fix this. I am pretty sure it exists but my googling has not been effective in this area. Some things that seem dubious to me are the fact that eth0(the bridge) looks like an exact clone of peth0 from ifconfig. I would have expected them to have different HWaddr and at the very least different inet addr. Another dubious thing is the routing table, double routes one for each interface. Shouldn't that confuse the heck out of the OS? Lastly I have no clue why the next line is in the routing table: 169.254.0.0 0.0.0.0 255.255.0.0 U 1000 0 0 eth0 Here is that status of my system on boot with networking broken: mpower@dodtsair:~$ ifconfigeth0 Link encap:Ethernet HWaddr 00:22:15:3f:f2:0d inet addr:75.101.5.130 Bcast:75.101.5.255 Mask:255.255.255.0 inet6 addr: fe80::222:15ff:fe3f:f20d/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:462 errors:0 dropped:0 overruns:0 frame:0 TX packets:254 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:32133 (31.3 KB) TX bytes:29676 (28.9 KB)lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:575 errors:0 dropped:0 overruns:0 frame:0 TX packets:575 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:64462 (62.9 KB) TX bytes:64462 (62.9 KB)peth0 Link encap:Ethernet HWaddr 00:22:15:3f:f2:0d inet addr:75.101.5.130 Bcast:75.101.5.255 Mask:255.255.255.0 inet6 addr: fe80::222:15ff:fe3f:f20d/64 Scope:Link UP BROADCAST RUNNING PROMISC MULTICAST MTU:1500 Metric:1 RX packets:531 errors:0 dropped:80563353626 overruns:0 frame:0 TX packets:497 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:45589 (44.5 KB) TX bytes:54250 (52.9 KB) Interrupt:18 Base address:0xa000 mpower@dodtsair:~$ sudo brctl show bridge name bridge id STP enabled interfaces eth0 8000.0022153ff20d no peth0 mpower@dodtsair:~$ route -n Kernel IP routing tableDestination Gateway Genmask Flags Metric Ref Use Iface 75.101.5.0 0.0.0.0 255.255.255.0 U 0 0 0 peth0 75.101.5.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0 169.254.0.0 0.0.0.0 255.255.0.0 U 1000 0 0 eth00.0.0.0 75.101.5.1 0.0.0.0 UG 0 0 0 peth0 0.0.0.0 75.101.5.1 0.0.0.0 UG 100 0 0 eth0 mpower@dodtsair:~$ sudo ethtool eth0 Settings for eth0: Link detected: yes mpower@dodtsair:~$ sudo ethtool peth0 Settings for peth0: Supported ports: [ TP ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Supports auto-negotiation: Yes Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Advertised auto-negotiation: Yes Speed: 100Mb/s Duplex: Full Port: Twisted Pair PHYAD: 0 Transceiver: internal Auto-negotiation: on Supports Wake-on: pumbg Wake-on: g Current message level: 0x00000033 (51) Link detected: yes mpower@dodtsair:~$ sudo /etc/Xen/scripts/network-bridge status ============================================================10: peth0: <BROADCAST,MULTICAST,PROMISC,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast qlen 1000 link/ether 00:22:15:3f:f2:0d brd ff:ff:ff:ff:ff:ff inet 75.101.5.130/24 brd 75.101.5.255 scope global peth0 inet6 fe80::222:15ff:fe3f:f20d/64 scope link valid_lft forever preferred_lft forever 11: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue link/ether 00:22:15:3f:f2:0d brd ff:ff:ff:ff:ff:ff inet 75.101.5.130/24 brd 75.101.5.255 scope global eth0 inet6 fe80::222:15ff:fe3f:f20d/64 scope link valid_lft forever preferred_lft forever bridge name bridge id STP enabled interfaces eth0 8000.0022153ff20d no peth0 75.101.5.0/24 dev peth0 proto kernel scope link src 75.101.5.130 75.101.5.0/24 dev eth0 proto kernel scope link src 75.101.5.130 169.254.0.0/16 dev eth0 scope link metric 1000 default via 75.101.5.1 dev peth0 default via 75.101.5.1 dev eth0 metric 100 Kernel IP routing tableDestination Gateway Genmask Flags Metric Ref Use Iface 75.101.5.0 0.0.0.0 255.255.255.0 U 0 0 0 peth0 75.101.5.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0 169.254.0.0 0.0.0.0 255.255.0.0 U 1000 0 0 eth00.0.0.0 75.101.5.1 0.0.0.0 UG 0 0 0 peth0 0.0.0.0 75.101.5.1 0.0.0.0 UG 100 0 0 eth0 ============================================================ I'll try the following before I send. ifconfig eth0 mtu 1496 That didn't work. Mike Power _______________________________________________ Xen-users mailing list Xen-users@xxxxxxxxxxxxxxxxxxx http://lists.xensource.com/xen-users
|
Lists.xenproject.org is hosted with RackSpace, monitoring our |