Re: [Xen-users] [XCP] Disconnected link status of network

[Todd Deshane <todd.deshane@xxxxxxx>]

On Sun, Jul 3, 2011 at 4:58 AM, Wei-Chih Chen <wcchen.tw@xxxxxxxxx> wrote:
> Hello Everyone,
>
> I've setup several hosts with XCP 1.0 and manage it through XenCenter.
> Each host has two NICs (NIC1 and NIC2), connected to different physical
> switches (sw1 and sw2 respectively).
> After installation, Network1 and Network2 are automatically created for the
> two NICs.
>
> Now I am trying to setup VLAN.
> I create an "External Network" called NetworkVLAN, assigne a VLAN ID, and
> link it to NIC2.
> On XenCenter, the Link Status of Network1 and Network2 are shown connected,
> but that of NetworkVLAN is disconnected.
> Does this mean packets of VMs attached to NetworkVLAN can not go outside to
> sw2?
> (i.e. These packets can only travel among VMs attached to NetworkVLAN?)
> Is there something wrong?
>

http://docs.vmd.citrix.com/XenServer/5.6.0fp1/1.0/en_gb/reference.html#networking-concepts-vlans

Note that "XenServer management interfaces cannot be assigned to a
XenServer VLAN via a trunk port."

> Thanks.
>
> Regards,
> Wayne
>
>
> _______________________________________________
> Xen-users mailing list
> Xen-users@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-users
>



-- 
Todd Deshane
http://www.linkedin.com/in/deshantm
http://www.xen.org/products/cloudxen.html
http://runningxen.com/

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users