[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Xen-users] XCP 1.0 Network Interfaces missing on pool slave after relocation
Use xe network-list, xe pif-list. You need to see if management
network have plugged (and configured) pif for slave host.
... better starts from reading administration guide about network
creation/configuration in xenserver.
On 16.11.2011 02:49, Mike Galvez wrote:
I relocated my hosts to a new data center. The pool
master booted fine and I changed the management IP and VMs started
fine as well. The slave host started, but it doesn't show to have
any NICs. If I exit to a command line I can list them with
ifconfig, but none show up in xsconsole. I can also see chatter on
the NIC LEDs and the switch ports. I didn't find any helpful old
posts here or on the Citrix site.
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users
|
