[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Xen-users] Booting dom0 on OMAP5432 board



On Tue, 2014-09-23 at 08:06 -0700, manul wrote:
> Hello,
>  I tried to boot Linux as Dom0 with instructions described on wiki -
> http://wiki.xen.org/wiki/Xen_ARM_with_Virtualization_Extensions/OMAP5432_uEVM.
> Even instructions are not full I found a way to launch Xen itself, but I was
> unable to get any output in console from Dom0 (corresponding kernel options
> enabled: CONFIG_HVC_XEN=y, CONFIG_HVC_XEN_FRONTEND=y). 
> 
> The last messages in console are:
> (XEN) 3... 2... 1... 
> (XEN) *** Serial input -> DOM0 (type 'CTRL-a' three times to switch input to
> Xen)
> (XEN) Freed 260kB init memory.
> 
> Dump shows that Linux stuck on:
> 
> c0014aac:     e59f2010        ldr     r2, [pc, #16]   ; c0014ac4
> <register_ipi_completion+0x18>
> 
> Could anyone suggest any ideas on what might be wrong here? 

I don't have this platform but if you can show what you did,
e.g. .config and your boot.scr/bootcmd etc, then I may be able to spot
the mistake.

Ian.



_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
http://lists.xen.org/xen-users


 


Rackspace

Lists.xenproject.org is hosted with RackSpace, monitoring our
servers 24x7x365 and backed by RackSpace's Fanatical Support®.