Re: [Xen-users] Enable Data Execution Prevention for DomU

[Thomas Strobel <ts468@xxxxxxxxx>]

On 02/09/2015 11:58 AM, Ian Campbell wrote:
> On Mon, 2015-02-09 at 10:29 +0100, Thomas Strobel wrote:
>> Hi!
>>
>> I'm new to the xen-user mailing list, so before I start asking specific
>> questions, some general information. I'm trying to integrate Xen, the
>> XAPI toolstack
> Note that the xapi toolstack is developed and supported elsewhere, you
> may have more luck on the xen-api list, which is its development list.
>
> Since the biggest xapi user is xenserver, you may also have more luck
> over on the xenserver.org forums and lists, even if you aren't using
> xenserver, since many of the xapi devs are there.
Sorry, my introduction might have been confusing. I plan to use the xapi
tools later on, but for now I'm just using the xl toolstack. Xen 4.5
however has a few patches from the xenserver patch queue applied. If you
think they are causing the problem, I can remove them and try with Xen
4.5 as released.
>> The important part out of the VM configuration is:
>> builder="hvm"
>> memory=4096
>> vcpus=4
>> nx='1'
>> nestedhvm='1'
> This doesn't look like a xapi configuration file though. So perhaps I'm
> confused --  what toolstack are you using?
>
> The method for enabling NX will be inherently toolstack specific. What
> you quote above looks right for an xl toolstack at least.
Yes, it is xl toolstack. Any idea what could prevent NX from being enabled?
>
> Ian.
>
Thomas

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
http://lists.xen.org/xen-users