Re: [Xen-users] I want to create a network for my Xen VM and need help.

[Jason Long <hack3rcon@xxxxxxxxx>]

Thank you so much.

I use Fedora 23 as dom0 and my current eth0 configuration is :

enp7s0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500

        inet 172.30.9.20  netmask 255.255.255.0  broadcast 172.30.9.255

        inet6 fe80::52e5:49ff:fe40:c48f  prefixlen 64  scopeid 0x20<link>

        ether 50:e5:49:40:c4:8f  txqueuelen 1000  (Ethernet)

        RX packets 4870061  bytes 5217699196 (4.8 GiB)

        RX errors 0  dropped 0  overruns 0  frame 0

        TX packets 710609  bytes 50652946 (48.3 MiB)

        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

My questions are :

1- I use Fedora 23 as Dom0 and for create a bridge network in Xen what should I do? If possible, Please tell me about commands.
2- How about NAT? If I use "vif=['']" it mean NAT?
3- How about Static IP? If I use "vif=[192.168.1.1]" then it mean static IP?

Thank you.

On Sunday, May 8, 2016 5:27 PM, Simon Hobson <linux@xxxxxxxxxxxxxxxx> wrote:

Jason Long <hack3rcon@xxxxxxxxx> wrote:

> Can you tell me how can I enable networking for my Windows VM step by step? I don't know anything about bridge and...

So you've not learned anything from your last thread and are hoping asking again will get a different result ?

If you want step-by-step then you'll need to give *at the very least* the distro you are using and the version (from the interface name, I can see you're running one that's Poettering'ised).


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
http://lists.xen.org/xen-users

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
http://lists.xen.org/xen-users