[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [Xen-devel] AMD Phenom II 940: mm/vmalloc.c:110 vmap_page_range_noflush
On Thu, May 06, 2010 at 10:22:03PM -0400, Gerry Reno wrote: > On 05/06/2010 08:21 PM, Gerry Reno wrote: >> Ok, I tested with the new 2.6.32.12: (.config same) >> >> Case 1: Xen 4.0.0-rc8 / pv_ops dom0 kernel 2.6.32.12 >> >> Still pv_ops dom0 is not working properly. >> There are still call trace and other errors. The kernel does boot up >> but it takes again a long time to get the login prompt (about 3 mins). >> This is far longer than when I used 2.6.31.6 pv_ops dom0. Networking >> does not start properly (only see 'lo' and 'virbr0'), so I have to >> restart it manually and then I see my bridge 'br0' and 'eth0'. >> Can't find device "br0" >> /etc/xen/scripts/network-bridge: line 240: "sigerr" command not found. >> And it is trying unsuccessfully to start some laptop feature like >> S99powernap (unknown job) and also S28-libvirt-bin fails (maybe >> network related?). >> >> >> Case 2: pv_ops domU kernel 2.6.32.12 (no xen dom0): >> >> Now the straight linux kernel (no xen dom0) boots right up and goes to >> login prompt in normal timeframe. Networking starts correctly. >> Things look pretty normal. >> >> >> Observation: >> I'm getting slightly different output on console and serial console. >> Some errors show on one but not the other. Shouldn't these be >> identical? >> >> >> I'm attaching both serial console outputs. >> >> menu.lst is same as before (just .12 instead of .10) >> >> -Gerry >> >> > And I'm attaching the syslog from Case 1 (pv_ops dom0). > You should be posting two things: 1) xm dmesg 2) dmesg Aka the full boot log, from both Xen hypervisor and dom0 Linux kernel. -- Pasi _______________________________________________ Xen-devel mailing list Xen-devel@xxxxxxxxxxxxxxxxxxx http://lists.xensource.com/xen-devel
|
Lists.xenproject.org is hosted with RackSpace, monitoring our |