Re: inet and brd for peth0 drops in setup_bridge_port() (Re: [Xen-users] Dom0 network problem)

["Matt Richardson" <shortpath@xxxxxxxxx>]

On 12/21/06, Christopher G. Stach II <cgs@xxxxxxxxx> wrote:
> Christopher G. Stach II wrote:
> > Matt Richardson wrote:
> >> I was having the same difficulty with Etch: networking was broken on
> >> Dom0 when using network-bridge, worked fine with network-dummy.
> >> However, I was just able to install a DomU using debootstrap with
> >> network-dummy selected, then had to switch to network-bridge and
> >> restart xend to get networking happening for both.  ifconfig  on Dom0
> >> shows fe:ff:blah MAC addresses for the bridge, vif, and peth
> >> interfaces, which seems odd to me.  It also seems odd that networking
> >> for Dom0 only works when a DomU is brought up.  But I'm new to this,
> >> so a lot of it seems odd.
> >>
> >
> > What state was networking left in when the script ran?  Were the
> > interfaces in t
> >
>
> Weird, got chopped.  Were the interfaces in the bridge?  What did
> ifconfig show?  What did brctl show?
>
> --
> Christopher G. Stach II
>
>
> _______________________________________________
> Xen-users mailing list
> Xen-users@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-users
I won't be able to reproduce it for at least a couple of days;
however, the earlier thread started by Toshinao had ifconfig output
that was identical to mine.  If I can get in to work for a couple of
hours next week, I'll get the output for brctl and ifconfig.

--
Matt

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users