Re: [Xen-users] Problems with xen/kernel / autoloading

["Ulrich Windl" <ulrich.windl@xxxxxxxxxxxxxxxxxxxx>]

On 31 Jan 2007 at 21:51, Per Olav wrote:

> Hi, I'm new to Xen, and have gotten my system up and running, but there 
> are some problems.
> 
> When I boot the system cold, the xen-kernel locks up with an error like 
> this:
> 
> ACPI: PCI Interrupt 0000:03:0a.0[A] -> GSI 22 (level, low) -> IRQ 18
> 
> The PCI address of the device is not the same each time.

Could it be that the PCI address is always the same, but the interrupt differs?
;-)

I never cared which slot uses which IRQ.

> 
> If I boot my system with the standard Etch kernel (2.6.17-2-686), it 
> boots fine, and when I do a reboot from this kernel into the xen kernel 
> it looks, and boots fine. I've never seen an error like this. What could 
> the problem be?

The above is not an error. AFAIK.

Ulrich


> 
> I'm using the Xen kernel provided in Debian Etch, 2.6.18-3-xen-686
> 
> Cheers
> Per Olav
> 
> 
> _______________________________________________
> Xen-users mailing list
> Xen-users@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-users



_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users