RE: [Xen-users] install error: No module ehci-hcd found for kernel 2.6.18.8-xen0 (I added the module "EHCI HCD" in buildin Xen0-Kernel)

["You, Yongkang" <yongkang.you@xxxxxxxxx>]

Try to add "--buildin ehci-hcd" after your mkinitrd command.

 

Best Regards,

Yongkang You

 

---

From: xen-users-bounces@xxxxxxxxxxxxxxxxxxx [mailto:xen-users-bounces@xxxxxxxxxxxxxxxxxxx] On Behalf Of Yuming fang
Sent: Wednesday, September 10, 2008 10:34 PM
To: xen-users
Subject: [Xen-users] install error: No module ehci-hcd found for kernel 2.6.18.8-xen0 (I added the module "EHCI HCD" in buildin Xen0-Kernel)

Hi, everyone,

When I installed the Xen3.3, I encountered a error:
No module ehci-hcd found for kernel 2.6.18.8-xen0, aborting.

This error came up when I used the command "mkinitrd -v -f --with=aacraid --with=sd_mod --with=scsi_mod /boot/initrd-2.6.16-xen0.img 2.6.16.29-xen0".

At first, I thought it might be the problem that I did not include the "ehci-hcd" module in buildin Kernel. However, when I used the command "make linux-2.6-xen0-config CONFIGMODE=menuconfig KERNELS="linux-2.6-xen0" and included this module(Device driver->USB support->EHCI HCD USB 2.0 support)  in Kernel, the error information was still "
No module ehci-hcd found for kernel 2.6.18.8-xen0, aborting."

It seems that the error is not related with the module in buildin Kernel(this could configure in menuconfig). So could anyone tell me the cause of this error?

Thanks.
Leo

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users