Re: [Xen-users] ARM: Xen on Vexpress

[Julien Grall <julien.grall@xxxxxxxxxx>]

On 06/04/2014 02:14 PM, Jeenu Viswambharan wrote:
> On Wed, Jun 04, 2014 at 12:41:24, Julien Grall wrote:
>> On 06/04/2014 10:43 AM, Ian Campbell wrote:
>>> On Tue, 2014-06-03 at 18:11 +0100, Jeenu Viswambharan wrote:
>>>> Hi,
>>>>
>>>> I've built necessary files and setup uboot and board to boot Xen
>>>> on Vexpress following the Wiki page. But what I see is u-boot
>>>> going silent, presumably after it jumps to Xen. My logs are
>>>> attached.
>>>
>>> Jeenu, Which version of Xen are you building?
>>>
>>> Skimming that wiki page it seems to be describing how to use an
>>> older version of Xen (like 4.3 or early 4.4 development era) and not
>>> a modern 4.4 or 4.5 development hypervisor.
>>
>> The wiki page is based on a Xen 4.4 with a proper multiboot support. I
>> don't think there was many change in Xen since the page were written
>> (back in september 2013).
> 
> So I take it that the Wiki (release tags, build instructions) are all
> up-to-date to be used with Xen 4.4.0? I'd have to connect my debugger to
> the board and see what's going on... :/

Honestly I didn't try to boot Xen on the vexpress for 6 months now. Xen
may have been broken since this date.

Did you try to enable early printk?

Regards,

-- 
Julien Grall

_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxx
http://lists.xen.org/xen-users