Re: [Xen-devel] Problems booting on a Dual-Xeon with 2.4 and 2.6 kernels

[Christian Limpach <Christian.Limpach@xxxxxxxxxxxx>]

On Tue, Aug 10, 2004 at 12:16:21AM +0200, Sven Kretzschmar wrote:
> Ok, here are the outputs:
> 
> 1.) the config diffs (I can not garantee any more that this is an orginal 
> .config,
>      because I now already tried some things to make it perhaps work..., 
> however it's still
>      CONFIG_NOHIGHMEM=y ?!):

The failure you showed can only occur with a kernel with CONFIG_HIGHMEM
enabled.  In any case, highmem should now work on 2.6.

Re the 3ware problems:
Could you build a 2.6 dom0 kernel with #define TW_DEBUG added before
the dprintk macro gets defined around line 248 (the file is
linux-2.6.7-xen0/drivers/scsi/3w-xxxx.h), like this:
#define TW_DEBUG 1
#ifdef TW_DEBUG
#define dprintk(msg...) printk(msg)
#else
#define dprintk(msg...) do { } while(0)
#endif

Also, does the boot get to the point where it prints a line like:
Found a 3ware Storage Controller...
I couldn't find a mail from you which included dmesg output of a failed
2.6 boot, please include all the output from Xen and from dom0 when
you boot with TW_DEBUG enabled.

    christian



-------------------------------------------------------
SF.Net email is sponsored by Shop4tech.com-Lowest price on Blank Media
100pk Sonic DVD-R 4x for only $29 -100pk Sonic DVD+R for only $33
Save 50% off Retail on Ink & Toner - Free Shipping and Free Gift.
http://www.shop4tech.com/z/Inkjet_Cartridges/9_108_r285
_______________________________________________
Xen-devel mailing list
Xen-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.sourceforge.net/lists/listinfo/xen-devel